Painting or staining is the process that you need to have to wait for it to dry. If you find yourself doing something that required painting/staining both sides, you have to paint one side, wait a day for it to dry, then come back the next day to paint the other side. So it's very difficult to finish painting on one weekend.
However, if you try to paint the other side right after painting one side, you end up with unwanted paint lines on the product.
To allow me to paint both side of the piece of wood in the same day, I came up with this idea to allow me to stain both sides of my piece of wood.
How did I make it?
First I measure the length and the diameter of my push pins.
My push pin is 1/2 in for length and 3/8 in for diameter.
Next, I take 3/8 in drill bit and use a painter tape to tape about 1/2 in from the tip (the length of my pin) as my cue to stop drilling.
Then I drill holes in the piece of scrap wood about 3 inches apart. They don't have to be exact measurement. I use painter's tape to make my depth but you can you the stop guide to do the samething.
Be careful when handling these pin to avoid hurting yourself, use glove if necessary.
As you can see in the picture below, your material will lay on top of the needle point so it doesn't ruin your new stained surface.
There you have it, now you can paint or stain one side and flip it over, put it on this and paint, stain another side without ruining the new painted stained surface.Worse case you get are a few needle holes on your surface but it will barely visible, especially on wood surface.
Happy painting/staining and thank you for reading.
If you find my blog helpful, please click on the ads to support this blog.
See you in the next Weekend DIYer tip.